| The end shapes can be selected from among
the above seven basic shapes (or eight depending
on manufacturing methods) and the following
special shapes. (But type T&T is not
possible) |
 |
 |
 |
||
 |
 |
 |
||
| Closed end | O.D of end is almost the same as I.D | O.D of type B's end<O.D of end<O.D |
||
 |
 |
 |
||
 |
 |
 |
||
| O.D of end is almost the same as O.D | I.D<O.D of end<O.D of type A's end |
|||
 |
 |
 |
||
 |
 |
Special shapes are combinations of typeA
~ F in the following figure. Example:C&E combination |
||
Detailed drawing |
Detailed drawing |
* If you don't specify the thickness of metal for the thick part of typeT, we will use our standard thickness. * As for the thick part of typeT, you can open holes or process it in concavo-convex way. * Semi-seamless metal bellows are not producible as typeT. * For typeA,C,E, and F, there are limitations even on the producible thickness, depending on the length and diameter. |
  |